|
Product Details:
|
| Purpose: | Braking | Withstand Voltage: | 2000V/1min |
|---|---|---|---|
| Resistance: | 144Ω±10% | Relative Humidity: | 20%-85% |
| Temperature Range: | -5℃-45℃ | Specifications And Dimensionsl: | ф50*13*22.5（mm） |
| High Light: | Electromagnetic Brake DC24V,Compact Electromagnetic Brake,Stepping Motor Electromagnetic Power Off Brake |
||
Micro stepping motor electromagnetic brake motor power off brake electromagnetic power off brake
Product Name: electromagnetic brake
Product model: dsn5013x-s
Product voltage: DC24 V power: 4.8 w current: 0.2 a
Product specification: diameter: ф 50mm height: 22.5MM
Product features: the brake has the advantages of compact structure, convenient installation, wide applicability, low noise, high working frequency, sensitive action and reliable braking. It is an ideal automatic actuator in industrial modernization.
Workpiece principle and installation maintenance: the electromagnetic power loss brake is mainly composed of excitation part (yoke, coil, spring, armature), brake disc, spline sleeve and other main parts. The excitation part is installed on the engine base through the mounting screw. After adjusting the air gap to the specified value δ, screw out the hollow bolt reversely and tighten the excitation part. The spline sleeve is connected with the transmission shaft through the key, and the brake disc is meshed with the spline through the spline. When the coil is powered off, under the action of the spring, the friction between the brake disc and the armature, the end face of the frame (or the brake plate) is generated, which is transmitted to the transmission shaft for braking through the spline sleeve. When the coil is electrified, under the action of electromagnetic force, the armature is sucked to the yoke to release the brake disc and release the brake of the transmission shaft. (in case of power failure in equipment maintenance, the brake can be released by axially pulling the hand release mechanism.)
Before installation, the oil and foreign matters on the surface of the friction pair shall be removed
1) The braking torque can be increased according to the requirements, it needs to be customized!
2) Working voltage can be customized according to the requirements!
3) Can be customized less than the table size of the installation shaft hole, installation plate (flange) can be customized according to the requirements!
Service life: more than 500000 times under rated working conditions
Material description:
1. Armature: TISCO dt4c electrical pure iron
2. The Curie temperature curve is demagnetized without remanence
3. Copper base H62 copper, surface passivation treatment anti-oxidation
4. Brilliant material: Teflon tape, good insulation performance, in line with environmental requirements
5. The bayonet is made of imported stainless steel.
6. The armature was plated by electroless nickel plating, and the salt spray test lasted for 72 hours
7. The enameled wire adopts high-quality enameled wire imported from Germany, the temperature resistance grade is above 210 degrees, and the withstand voltage is more than 2000 v
| Quantity(Pieces) | 1 - 500 | 501 - 1000 | 1001 - 5000 | >5000 |
| Est. Time(days) | 10 | 15 | 20 | To be negotiated |
Contact Person: jason luo
Tel: +8618802564948
Fax: 86-769-2315-1292
